USB to rs232 converters are just never sold properly advertising what chip’s inside and right now I want to know if this one UART I’m working with perhaps is not playing fine with my existing converter cable.

I have this XScale PXA270 on a board, and it has only one full featured RS232 (FFUART) and I’m about to move things over to the lesser featured BTUART.

A theory is that my current USB converter that is based on a “Prolific PL2303” doesn’t play nicely on the serial port that isn’t a full RS232.

So I ran off and bought a new cable. I grabbed the only model I found in my local Kjell & Company store – it’s quite different looking than my existing but there’s no hint anywhere on the package or inside of it that says what chipset that empowers it.

A quick drive back home (I’m working from home in this assignment), I plugged it in and I got to see this depressingly familiar dmesg output:

usbcore: registered new interface driver usbserial
usbserial: USB Serial support registered for generic
usbcore: registered new interface driver usbserial_generic
usbserial: USB Serial Driver core
usbserial: USB Serial support registered for pl2303
pl2303 2-2.4:1.0: pl2303 converter detected
usb 2-2.4: pl2303 converter now attached to ttyUSB0
usbcore: registered new interface driver pl2303
pl2303: Prolific PL2303 USB to serial adaptor driver

So what now? I hate how (my) computers these days don’t have serial ports while the entire embedded world still very much uses them. I think I’ll go searching in my closet to see if I can find an old crap computer with a serial port to try.

Another theory is that the port simply is broken hw-wise on the dev board but that’s harder to check for me right now.

Update: it was (as usual) only my stupidity that prevented this from working. If I switch it over to the correct baudrate the usb converter does fine. But before I found that out, I did find a computer with a serial port and I did see it working on that too…